EMT Practice Test

1. Question Content...

---

Question1: Which agent is used only as part of a login script?

Question2: In which view would you find who made modifications to a Group?

Question3: Which two of the following are required for endpoint compliance monitors? (Choose two.)

Question4: How are logical networks assigned to endpoints?

Question5: By default, if more than 20 hosts are seen connected on a single port simultaneously, what will happen to the port?

Question6: How should you configure MAC notification traps on a supported switch?

Question7: Refer to the exhibit.

If you are forcing the registration of unknown (rogue) hosts, and an unknown (rogue) host connects to a port on the switch, what will occur?

Question8: Where are logical network values defined?

Question9: Which command line shell and scripting language does FortiNAC use for WinRM?

Question10: Which two agents can validate endpoint compliance transparently to the end user? (Choose two.)

Question11: In which view would you find who made modifications to a Group?

Question12: Which three of the following are components of a security rule? (Choose three.)

Question13: What capability do logical networks provide?

Question14: Which connecting endpoints are evaluated against all enabled device profiling rules?

Question15: Which two agents can validate endpoint compliance transparently to the end user? (Choose two.)

Question16: Where do you look to determine what network access policy, if any, is being applied to a particular host?

Question17: Where do you look to determine when and why the FortiNAC made an automated network access change?

Question18: In which view would you find who made modifications to a Group?

Question19: What would occur if both an unknown (rogue) device and a known (trusted) device simultaneously appeared on a port that is a member of the Forced Registration port group?

Question20: Which agent is used only as part of a login script?

Question21: Which agent can receive and display messages from FortiNAC to the end user?

Question22: Refer to the exhibit, and then answer the question below.

Which host is rogue?

Question23: During the on-boarding process through the captive portal, why would a host that successfully registered remain stuck in the Registration VLAN? (Choose two.)

Question24: Which system group will force at-risk hosts into the quarantine network, based on point of connection?

Question25: Which command line shell and scripting language does FortiNAC use for WinRM?

Question26: What would occur if both an unknown (rogue) device and a known (trusted) device simultaneously appeared on a port that is a member of the Forced Registration port group?

Question27: Where are logical network values defined?

Question28: Which three circumstances trigger Layer 2 polling of infrastructure devices? (Choose three.)